Bezel Ring Removal Tool for Surefire Z46 Flashlights.

Precision machined from aerospace grade 7075 aluminum with flat black anodization.
Allows for the removal of stock and aftermarket bezel rings without damaging your flashlight.

Recommended instructions:
Heating the bezel is recommended for removal of the stock Surefire bezel rings, because they are glued in place.
Put bezel in a dish of hot boiling water for 3-5 minutes.
Carefully handle flashlight with gloves or oven mitts.
Insert a screw driver into the bezel removal tool.
Rotate the tool counter-clock-wise to remove the bezel ring.
Insure strong downward pressure so the tool doesn't slip out from bezel ring groves.
Install new bezel ring in a clock-wise manner.


Compatible with:

Surefire
(Z46-Cren Side)
M3 (with later generation Z46 Head Units with Crenelated Bezel Ring)
M500 (with later generation Z46 Head Units with Crenelated Bezel Ring)
M900, M910 (with later generation Z46 Head Units with Crenelated Bezel Ring)
M961, M962 (with later generation Z46 Head Units with Crenelated Bezel Ring)


(Z46 Plastic Ring Side)
M3 (with early generation "Ribbed" Z46 Head Units with Flat Plastic Bezel Ring)
M500 (with early generation "Ribbed" Z46 Head Units with Flat Plastic Bezel Ring)
M900, M910 (with early generation "Ribbed" Z46 Head Units with Flat Plastic Bezel Ring)
M961, M962 (with early generation "Ribbed" Z46 Head Units with Flat Plastic Bezel Ring)
9AN Commander
KL2 LED Head Unit